Dell XPS DC01L Owner's Manual page 113

book.book Page 113 Tuesday, November 27, 2007 10:29 AM
1
10 Close the card retention door by snapping it into place to secure the card(s).
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the
cards can prevent the computer cover from closing properly or cause damage to
the equipment.
11 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card cable
connections.
NOTICE:
To connect a network cable, first plug the cable into the network device
and then plug the cable into the computer.
12 If you replaced a card that was already installed in the computer and you
removed the retention mechanism, reinstall the retention mechanism.
13 Before replacing the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
14 Snap the card retention mechanism into place, securing the PCI card.
1
2
card retention door 2
Removing and Installing Parts
release tabs (2)
113