Air Conditioner Use; Starting Your Air Conditioner - Whirlpool 1187680 Use And Care Manual

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 66°F (19°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTES:
In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
If the electronic control will not respond to touch pad or
remote control commands, it is necessary to unplug the unit
from the electrical outlet for 5 seconds before plugging
back in.

Starting Your Air Conditioner

Models without heat
8

AIR CONDITIONER USE

Models with heat
1. Press POWER to turn on air conditioner.
2. Choose mode. See "Mode."
3. Choose fan speed. See "Fan Speed."
4. Choose temperature. See "Temperature."
Mode
1. Press and hold MODE.
2. Choose COOL, FAN, HEAT (on some models) or POWER
NOTE: When the unit is turned on, it will display the previous
settings for the mode, fan speed and temperature.
SAVER.
Cool—Cools room. Press FAN SPEED to choose fan
speed. Then adjust the temperature by pressing the up or
down arrow buttons.
Fan—Operates the fan at Low, High or Turbo (on some
models) speed, without cooling.
Power Saver—The fan will switch from the set fan speed
to LOW whenever the compressor turns off in response to
the set temperature. When the compressor cycles back
on, the fan will return to the set fan speed.
Heat (on some models)—The unit will circulate and heat
the air.
When heater is powered off, low fan will automatically
stay on and run for 60 seconds. Low Fan indicator light
will blink while the low fan is operating.