Kraus KGW-1700 Installation Instructions

MODEL-KGW-1700
Product Description and Measurements
Installation Instruction
Single Lever Washbasin Mixer
Thank You
Dear Valued Customer,
Kraus would like to take this opportunity to thank you for purchasing Kraus products. It is our sincere
hope that you are completely satisfied with your new purchase. We welcome any questions or comments
you may have and look forward to assisting you in the future.
Sincerely
Kraus customer service department
Prior To Installation Steps
1. Unpack your new product and ensure that all the parts are contained in the packaging.
Keep the product in its original box until you ready to install it.
2. Shut off the water supply if replacing a previously-installed faucet,
3. Observe all plumbing and building codes in your area.
4, Itis recommended that installation of the product be done by a professional plumber.
Waterfall Faucet Installation
Please remember to turn off the hot and cold valves prior to installation.
STEP 1. Check to see that your set contains the following parts: =
-The faucet
= Hot and cold water lines
- One rubber washer
= - One brass washer
-Two mounting screws om
STEP 2. While holding the faucet facing you, locate the two larger openings at the base cana
of the faucet.
STEP 3. The left opening is for the hot water supply line and the right opening is for the
'cold water supply line.
STEP 4, Gently screw in the hot and the cold water lines. Make sure the waterlines are tightly | /
'screwed in place. U
STEP 5. Insert the waterlines through the faucet opening in the countertop and place the Ș g
faucet on the countertop. Make sure the faucet is facing forward and is aligned properly.
STEP 6. From underneath the countertop, place the rubber washer first so that it sits on
top of the metal washer, Be sure to align the openings on the washers with the openings panara
on the faucet. j Eear
STEP 7. Screw in the mounting screws through the washers and into the faucet from LA amun
undemeath the countertop,
`
STEP 8. Tighten the brass nuts (located on the mounting screws) until the faucet is held tightly in place.
STEP 9. Connect the hot and cold water supply lines to the corresponding waters supply valves.
100-775-0703; or visit our website at www.kraususa.com.