HIKOKI CR 12DA Handling Instructions Manual
Hide thumbs
Also See for CR 12DA:
- Handling instructions manual (113 pages) ,
- Handling instructions manual (48 pages) ,
- Handling instructions manual (196 pages)
Related Manuals for HIKOKI CR 12DA
Summary of Contents for HIKOKI CR 12DA
- Page 1 CR 12DA Handling instructions 使用說明書 취급 설명서 Hướng dẫn sử dụng คู ม ื อ การใช ง าน Petunjuk pemakaian...
-
Page 6: General Power Tool Safety Warnings
English c) Prevent unintentional starting. Ensure the GENERAL POWER TOOL SAFETY switch is in the off -position before connecting WARNINGS to power source and/or battery pack, picking up or carrying the tool. WARNING Carrying power tools with your nger on the switch Read all safety warnings, instructions, illustrations and or energising power tools that have the switch on speci... -
Page 7: Additional Safety Warnings
English h) Keep handles and grasping surfaces dry, clean ADDITIONAL SAFETY WARNINGS and free from oil and grease. Slippery handles and grasping surfaces do not 1. Preparing and checking the work environment. Make allow for safe handling and control of the tool in sure that the work site meets all the conditions laid forth unexpected situations. -
Page 8: Caution On Lithium-Ion Battery
English If you cut a large pipe, large block of wood, etc., that CAUTION ON LITHIUM-ION BATTERY exceeds the cutting capacity of a blade; there is a risk that the blade may contact with the inner wall of the pipe, To extend the lifetime, the lithium-ion battery equips with the wood, etc., resulting in damage. -
Page 9: Regarding Lithium-Ion Battery Transportation
English 2. If liquid leaks onto your skin or clothes, wash well with SYMBOLS clean water such as tap water immediately. There is a possibility that this can cause skin irritation. WARNING 3. If you nd rust, foul odor, overheating, discolor, The following show symbols used for the machine. -
Page 10: Specifications
English NOTE APPLICATIONS Due to HiKOKI’s continuing program of research and development, the speci cations herein are subject to ○ Cutting metal and stainless steel pipe. change without prior notice. ○ Cutting various lumber. ○ Cutting mild steel, aluminum and copper plate. -
Page 11: Mounting And Operation
(1) If a part of the broken saw blade is sticking out of the not cause the pilot lamp to blink in red (every second), small slit of the blade holder, pull out the protruding part please take the charger to the HiKOKI Authorized and take the blade out. Service Center. -
Page 12: Maintenance And Inspection
Allow the tool and battery to thoroughly cool. Low Voltage Protection Recharge the battery. MAINTENANCE AND INSPECTION Important notice on the batteries for the HiKOKI cordless power tools CAUTION Please always use one of our designated genuine Be sure to turned off the switch and remove the battery batteries.
Need help?
Do you have a question about the CR 12DA and is the answer not in the manual?
Questions and answers