U-Line H-4563 Manual

π
ANTI-STATIC MAT
ANTI-FATIGUE CONDUCTIVE MAT
INITIAL MAT USE AND STORAGE
1. Unroll mat within a few days of receipt. Let mat lay
for 24 hours at room temperature before using.
If the mat will not lie flat, move to a warm area. Heat
will cause the vinyl mats to become more pliable
and lay flat more quickly.
2. To store mats, roll them up and store lengthwise in a
dry area at moderate temperature.
CAUTION! Do not stand on edge or crush.
NOTE: Regular maintenance of your mat is
critical to extend mat life and appearance.
It is recommended a regular maintenance
schedule be followed. Frequency will depend
on traffic and soil conditions.
PERIODIC INSPECTION
Periodic inspection is recommended to check for tears.
To repair a damaged area, glue the section together
with cyanoacrylate ester type (super glue) adhesive.
1. Fasten the ground cord to the most convenient
snap fastener.
NOTE: Mat must be grounded to effectively
drain static electricity.
2. Check the fit of the floor mat. Place the floor mat in
front of the equipment so anyone approaching the
area must first come in contact with the mat.
CAUTION! The mat must not come in contact
with the conductive table legs or any other
parallel path to the ground that does not have
a current-limiting resistor.
3. Unwind just enough ground cord to reach a suitable
building ground. A ground cord can be fastened
to a grounded wall outlet first by shutting off the
power to such outlet and then removing the cover
plate and attaching to one of the screws holding the
receptacle box. Remove only one screw.
PAGE 1 OF 3
1-800-295-5510
uline.com
USE AND CARE
MAINTENANCE
1. Shake Out Or Sweep Daily – Daily shake dirt and
debris or sweep with a broom to remove surface
dirt. Sweep the area underneath the mat before
replacing it to remove any dirt or debris that could
cause premature wear and reduce slip hazard.
2. Hose Or Damp Mop Weekly – Mats can be
washed off with a hose or pressure washer, or
damp mopped with a non-abrasive, water-based
detergent, mild soap, or residue-free static control
cleaning solution. Let the mat dry completely before
allowing foot traffic to resume.
CAUTION! Do not use rotary scrubbers,
vacuums or any other mechanical cleaners
or scrubbers to clean. Do not use solvents, pH
detergents or alkalis directly on the mat or use
the mat in areas where these are used.
INSTALLATION
NOTE: Do not remove receptacle from the box.
For personnel unfamiliar with making electrical
connections, it is recommended that the
ground connections be done by an electrician.
4. It is important to make proper ground connections
to prevent personal shock in the unlikely event that
the mat is accidentally electrified. Use only cords
supplied with the mat. Take care not to short-circuit
the ground cord or floor mat by bringing the mat into
contact with a hard ground.
IMPORTANT! For proper function, a heel
grounder or other conductive footwear must
be used when standing on the mat.
NOTE: Electrical continuity should be checked
between the floor mat snap terminal and
ground.
Para Español, vea página 2.
Pour le français, consulter la page 3.
1223 IH-894