9
122
Roll the rear wheel as far
forward as possible and loop
chain 7 over the sprocket.
z
Insert right adjusting plate 6
in the swinging arm in such a
way that anti-twist stop 10 is
vertical.
Lift the rear wheel and work
rear axle 5 through the adjust-
ing plate and into the brake-
caliper carrier and the rear
wheel.
Make sure that the rear wheel
is seated against the anti-twist
stop.
Insert left adjusting plate 4.
Install axle nut 1 with its wash-
er, but do not tighten the nut
at this point.
If necessary, move the brake
line until rubber hose 11 is in
guide 12.
Adjust the chain tension
(
115).
Front-wheel stand
Installing auxiliary stand
at front wheel
The BMW Motorrad front
wheel stand is not designed
to support motorcycles not fitted
with a centre stand or without
other auxiliary stands. A motor-
cycle resting only on the front