BMW S 1000 RR Rider's Manual page 132

9
128
Install socket 3 in the socket,
making sure that retainer 2 en-
gages
Install the cover.
z
Replacing parking-light
bulb, right
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove cover 1.
Push down retainer 2 (using a
screwdriver if necessary) and
pull socket 3 out of the head-
light housing.
Remove bulb 4 from the sock-
et.
Replace the defective bulb.
Do not touch the glass of
new bulbs with your fingers.
Use a clean, dry cloth to hold
the bulbs when handling them.
Dirt deposits, in particular oil and
grease, interfere with heat radi-
ation from the bulb. This leads
to overheating and shortens the
bulb's operating life.