Icom UT-111 Instruction Manual page 23

Model UT-111 LTR® Logic Board
4.2
UT-111 Logic Board Programming
Programming the UT-111 is accomplished with Software supplied by
Icom. The opening screen of Icom Cloning Software displays three
programming options. Select the UT-111 option to program the UT-11]
Logic Board. The UT-111 software uses the same DOS commands and is
configured similar to the mobile or portable radio software.
Prior to programming the UT-111 Logic Board, information regarding
the system technical requirements, features available and general operation
must be obtained from the system operator. Other non-system features
can be selected and programmed based on the customer's requirements.
Please refer to the Operation section of the manual for specific information
on the functionality of each of the UT-111 features.
Global Features Programming (Figure 5)
Refer to Figure 5 to view an example of the programming
described in this section.
Figure 5
20