Icom UT-111 Instruction Manual page 20

4 * Programming
To enable the trunking function, use the Channel
Attributes (CH Atr) field to open the menu. Select
the SmarTrunk ON/OFF function. This will place the
selected channel bank | (Bnk 1T) in the trunking
mode. The word "SmarTrunk" is displayed vertically
to the left of the channel numbers indicating bank |
is assigned to trunking operation.
Other basic radio features such as CTCSS / DCS,
Selective Call, ANI and Scan are not compatible with
the trunking mode of operation and should not be
enabled, An additional Trunking or Conventional
bank may be programmed as desired. If an additional
Trunking Bank is programmed, the trunking data
programmed into the UT-111 for bank 1 will apply to
bank 2.
Note: The SmarTrunk ON/OFF function is used to
enable both UT-105 SmarTrunk and UT-111 LTR
cards.
Mobile Radio Programming
The following programming examples were developed for
the IC-F400 series radios. They may be used as a guide for
other mobile models compatible with the UT-111 Logic
Board,
17