Appendix B Application Standards; List Of Application Standards; Emc Compliance Declaration; Emc Product Standard - INVT SP100 Series User Manual

SP100 series solar pump inverter
B.1 List of application standards
The following table describes the application standards that inverters comply with.
IEC/EN 61800-3
IEC/EN 61800-5-1
IEC62109-1
IEC62109-2
B.2 EMC compliance declaration
Electro Magnetic Compatibility (EMC) describes the ability of electronic and electrical
devices to work properly in the electromagnetic environment and not to generate
electromagnetic interference that affects other local devices or systems. The inverter is
compliant with the EMC product standard (EN 61800-3) and applied to both the first
environment and the second environment.
B.3 EMC product standard
The EMC product standard (EN 61800-3) describes the EMC requirements on inverters.
Application environment categories:
First environment: Civilian environment, including application scenarios where the
inverter is directly connected without intermediate transformer to a low-voltage power
supply network which supplies residential buildings.
Second environment: All locations outside a residential area.
C1: Rated voltage lower than 1000V, applied to environments of Category I.
C2: Rated voltage lower than 1000 V, non-plug, socket, or mobile devices; power drive
systems that must be installed and operated by specialized personnel when applied to
environments of Category I
Note: The product may generate radio interference in some environments, and you
need to take measures to reduce the interference.
Category C3: Rated voltage lower than 1000V, applied to the second environment. They
cannot be applied to the first environment.
202501 (V1.1)

Appendix B Application standards

Adjustable speed electrical power drive system. Part 3: EMC
requirements and specific test methods
Adjustable speed electrical power drive systems. Part 5-1: Safety
requirements — Electrical, thermal and energy
Safety of power converters for use in photovoltaic powetsystems -Part
1:General requirementse
IEC62109-2:2011Safety of power converters for use in photovoltaic
power systems -Part 2:Particular requirements for inverterse
Application standards
108