Draper ETCT Instructions Manual
Draper ETCT Instructions Manual

Draper ETCT Instructions Manual

6 - 42v dc circuit tracer and detector

Advertisement

EN
Original Instructions
Version 1
April 2024
6 - 42V DC
CIRCUIT TRACER
AND DETECTOR
24702

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ETCT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Draper ETCT

  • Page 1 Original Instructions Version 1 April 2024 6 - 42V DC CIRCUIT TRACER AND DETECTOR 24702...
  • Page 2: Product Introduction

    Any other application beyond the conditions established short & open circuits without damaging the wire insulation. for use will be considered misuse. Draper Tools accepts no Equipped with a sensitivity controller & flexible probe for responsibility for improper use of this product.
  • Page 3: Health And Safety Information

    3. Health and Safety Information Important: Read all the Health and Safety instructions before attempting to operate, maintain or repair this product. Failure to follow these instructions may result in injury or damage to the user, the product or the workpiece. • ALWAYS follow the instructions and procedures listed • After checking the vehicle, ensure that all the in the vehicle’s service manual before using this...
  • Page 4 5. Identification Carefully remove the product from the packaging and Please contact the Draper Helpline; contact details can examine it for any signs of damage that may have be found at the back of this manual. occurred during shipment. If any part is damaged or missing, do not attempt to use the product.
  • Page 5: Installing The Battery

    6. Installing the battery 1. To fit or replace the battery unclip the battery compartment (7) for the detector and (8) for the sender. 2. Fit 1 X 9V battery – ensuring that the battery is fitted in the correct +/- orientation. 3.
  • Page 6 7. Operation 7.3 Wire Tracing • If the audible signal decreases or disappears there is an open circuit or bad connection. •  If the audible signal is difficult to pick up increase the sensitivity of the receiver. 7.4 Checking for Short Circuits (10) 1.
  • Page 7: Maintenance, Storage And Disposal

    8. Maintenance, Storage and Disposal WARNING! Do not attempt to repair or service this product. Any servicing or repairs must be carried out by a qualified person. • Wipe the case with a damp cloth and a mild detergent. DO NOT use solvents or abrasives to clean the tester. • Turn both the receiver and sender off when not in use and remove the batteries if stored for a long period of time.
  • Page 8: Contact Details

    Telephone Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 General Fax: +44 (0) 23 8026 0784 Please contact the Draper Tools Product Helpline for repair and servicing enquiries. © Published by Draper Tools Limited © Published by Draper Tools Limited...

This manual is also suitable for:

24702

Table of Contents