Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Draper 24709
Summary of Contents for Draper 24709
- Page 1 Original Instructions Version 1 April 2024 SONIC BELT TENSION TESTER 24709...
-
Page 2: Product Introduction
The meter can measure the vibration by using the conditions established for use will be considered misuse. microphone to convert the tension level when installing Draper Tools accepts no responsibility for improper use or adjusting a new belt. of this product. -
Page 3: Health And Safety Information
3. Health and Safety Information Important: Read all the Health and Safety instructions • The battery must be replaced with one with the same before attempting to operate, maintain or repair this specification. product. Failure to follow these instructions may result in • When replacing the battery check that it is fitted in injury or damage to the user, the product or the vehicle. -
Page 4: Battery Installation
5. Identification Carefully remove the product from the packaging and Please contact the Draper Helpline; contact details can examine it for any signs of damage that may have be found at the back of this manual. occurred during shipment. If any part is damaged or missing, do not attempt to use the product. -
Page 5: Probe Installation
6. Probe Installation 8. Operation 3. Press the ‘POWER’ button (8) until the screen turns on. 4. The following data will be displayed on the screen. Fig.5 A. Mas: belt mass B. Wid: belt width C. Spa : tangent line span D. -
Page 6: Taking A Measurement
9. Taking a Measurement Formula T = 4 X M X W X S X 10 1. Place the probe microphone (1) within 10mm of the belt and press the ‘MEASURE’ button (9). T = Tension of span length (N) W = Width (mm) or number or ribs/strands 2. -
Page 7: Maintenance, Storage And Disposal
10. Measurement Hints & Tips 12. Maintenance, Storage and Minimum Span Length Disposal • When measuring a synchronous belt, the span length needs to be more than 20 times the tooth pitch length. • After use, wipe clean the tester and store in the case • When measuring a V-belt, the span length needs to be supplied. -
Page 8: Contact Details
Telephone Sales Desk: +44 (0) 23 8049 4333 General Enquiries: +44 (0) 23 8026 6355 General Fax: +44 (0) 23 8026 0784 Please contact the Draper Tools Product Helpline for repair and servicing enquiries. © Published by Draper Tools Limited © Published by Draper Tools Limited...
Need help?
Do you have a question about the 24709 and is the answer not in the manual?
Questions and answers