Advertisement
BEFORE INSTALLATION :
1. This system operates from 11 volts DC to 30 volts DC, negative ground.
2. Please install this system according to the instructions in this manual.
3. Do not disassemble the camera or the monitor. This voids the warranty. Disassembling the
camera will compromise the waterproof seal.
4. Connect the system to an ignition switched power source. Connection to a battery source will
reduce battery life.
** WARNING **
1. To prevent electrical shock, DO NOT OPEN THE MONITOR CASE. There are potentially lethal
voltages Inside the monitor. There are no user serviceable parts inside. If evidence of tampering is
detected, the warranty will be considered void.
2. Keep monitor away from leaking water, rain, moisture etc. it is NOT waterproof. Any moisture
Inside the monitor could cause extensive damage.
3. Use the thumbscrews to mount the monitor to bracket.
INSTALLATION INSTRUCTIONS
AOM-78 MONITOR
1. Attach monitor inside vehicle in a location convenient to the driver (e.g. Center of dash, overhead
Or in dash).
2. Use a compression plate to attach the monitor bracket to the dash or overhead (See
3. Adjust mounting angle of the monitor to allow driver to easily view the screen from all seat
position (See Fig. 2).
4. If necessary, snap sun visor into groove on front face of monitor. Press all (4) sides of the v
to snap it into place.
MAINTENANCE :
Remove dust and dirt with a damp soft cloth. Heavier dirt should be removed with a damp soft cloth and mild
detergent. Do not use strong cleaning agents containing gasoline, thinner, benzene or alcohol. These substance
may damage the exterior surface of the monitor.
** CAUTION **
1. Before drilling, be sure no cable or wiring is on the other side. Be sure to drill a 19mm / ¾"
diameter hole only.
2. Feed as much cable as possible into vehicle and clamp securely. This reduces the possibility or
being hooked during production.
3. Keep all cables away from HOT, ROTATING and ELECTRICALLY NOISY components.
4. To increase protection of cable, place all excess wire and extension cable in convoluted tubing.
5. Do not twist camera cable and do not cut camera pigtail or cable.
5
Fig. 1).
isor
3.000
2.250
6
Advertisement
