Advertisement
WIRING CAMERA AND MONITOR
1. See wiring diagram for connections to ignition, ground and back-up circuit (See Fig. 3).
2. Wiring Camera :
Drill a 19 mm / ¾" diameter hole into vehicle body near the camera and bracket.
Connect camera connector to extension cable in vehicle.
Push extra cable into vehicle (Be careful not to kink cable) and fit grommet into hole.
Apply sealant around grommet to increase resistance to water penetration.
3. Wiring Monitor :
Insert extension cable into camera #1 position if (2) camera are used, be sure to mark each extension cable
property and plug second cable into camera #2 position.
Bundle excess cable together using a cable tie or vinyl tape. This will avoid possible
damage to cable during operation.
4. The red wire marked ACC is connected to an ignition power source, the black wire marked GND
is connected to chassis ground, and the blue wire marked BACK is connected to the vehicle's
back up circuit.
WATERPROOF CAMERA CONNECTOR
TO MONITOR
CAMERA #A INPUT
20 METERS
CROMMET TO SEAL THOUGH VEHICLE EXTERIOR
3A
TO MONITOR
GND
1A
BATT.
MODEL : AOM-78
POWER SOURCE : DC11V~30V
OUTPUT POWER : MAX 22W
MADE IN MALAYSIA
POWER
EXT
SPKR
CA1
CA2
FIGURE 3
7
OPTIONAL WIND DEFLECTOR
EMI FERRITE CORE
18 TEW RED (12V)
ACC
18 TEW BLK (GROUND)
WITH GROUND RING
18 TEW BLU (REVERSE TRIGGER)
18 TEW YLW (BATTERY)
REAR OF MONITOR
AFFIXING DISTANCE MARKERS TO THE MONITOR SCREEN
1. Clean monitor screen surface of fingerprints. Set the camera into the " DOWN " position. Place
distance indicators behind the vehicle at (3) feet, (5) feet and (9) feet along the width of the
vehicle. These distances are measured from the rear bumper. (Refer to fig. 4).
2. Attach the markers to the monitor screen over the images of the distance indicators. These
markers represent a distance of (3) feet, (6) feet and (9) feet from the back of the vehicle. (See
Fig. 4).
3. Affix the " STOP " marker on the monitor screen over the image of the rear bumper to locate
the rear bumper.
4. The monitor screen is now " calibrated " for distances behind the vehicle of (3) feet, (6) feet
and (9) feet.
3FT
6FT
MARKERS EXAMPLE
5
2
1
STOP
FIGURE 4
8
INDICATOR
WIDTH OF VEHICLE
Advertisement
