Table of Contents
Advertisement
Before drilling, be sure that no cable or wiring is on the other side. Clamp all wires
securely to reduce the possibility of them being damaged during installation and use.
Keep all cables away from hot or moving parts, and electrically noisy components.
Wiring Definitions:
Power connection:
Camera A input:
Camera B input:
Camera C input:
LCD panel:
Procedure:
1. Choose the monitor, junction box, and camera mounting locations.
2. Install all required cables in vehicle. A ¾" (19mm) hole should be drilled for passing
cables through vehicle walls, barriers, etc. After the intermediate cable is passed
through the hole, install the split grommet (included). If additional cable protection is
required install convoluted tubing over the cable.
3. After cable/wiring has been routed and components are in place, temporarily make all
system connections and perform a system function check. If system does not operate
properly, see the troubleshooting section of this manual.
4. If using an optional PanaVise
template provided on page 11. Install the PanaVise
using the #10 self-drilling screws (included).
**Important: Do not use screws other than those provided with the AOM683.
Void of warranty and serious product damage will occur.
6
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN INSTALLATION:
Pin 1 ACC +12V (Red)
Pin 2 Standby Reverse Trigger (Blue wire)
Pin 3 Ground (Black wire)
Pin 4 Audio Trigger (Blue w/white stripe wire)
Pin 5 Standby Left Trigger (Blue/Orange stripe wire)
Pin 6 Standby Right Trigger (Blue/Yellow stripe wire)
Connection for camera or camera extension cable
Connection for camera or camera extension cable
Connection for camera or camera extension cable
13-pin DIN cable connection: junction box to monitor.
®
stalk mount (available separately), use the mounting
®
mount to the LCD monitor
Advertisement
Table of Contents
