Replacing A Wlan Card; Removing A Mobile Broadband Or Wwan Card - Dell XPS RW491 Owner's Manual

Replacing a WLAN Card

NOTICE:
The connectors are keyed to ensure correct insertion. If you feel
resistance, check the connectors on the card and on the system board, and realign
the card.
NOTICE:
To avoid damage to the WLAN card, never place cables under the card.
1 Insert the
WLAN
board connector labeled "WLAN".
2 Press the other end of the
board until the card clicks into place.
3 Replace the M2 x 3-mm screw.
4 Connect the appropriate antenna cables to the
If the WLAN card has two triangles on the label (white and black),
connect the white antenna cable to the connector labeled "main" (white
triangle), and connect the black antenna cable to the connector labeled
"aux" (black triangle).
If the WLAN card has three triangles on the label (white, black, and gray),
connect the white antenna cable to the white triangle, connect the black
antenna cable to the black triangle, and connect the gray antenna cable to
the gray triangle.
NOTE:
presence of the gray antenna cable in your Mini-Card compartment depends
on the type of display.
5 Secure unused antenna cables in the protective mylar sleeve.
6 Replace the cover and tighten the captive screws.

Removing a Mobile Broadband or WWAN Card

NOTE:
WWAN is also available on an ExpressCard (see "Using ExpressCards" on
page 67).
1 Follow the procedures in "Before You Begin" on page 127.
2 Turn the computer over.
card connector at a 45-degree angle into the system
WLAN
The gray antenna cable may not be available in all computers. The
card down into the slot on the system
WLAN
Adding and Replacing Parts
card you are installing:
147