Dell XPS RW491 Owner's Manual page 99

H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E
T
that you are trying to copy is too large to fit on the disk, or the disk is full. Try
copying the file to a different disk or use a larger capacity disk.
A F I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S
Do not use these characters in filenames.
> | —
A T E F A I L U R E
G A 2 0
modules and, if necessary, replace them (see "Memory" on page 137).
G E N E R A L F A I L U R E
command. The message is usually followed by specific information—for
example, Printer out of paper. Take the appropriate action.
H A R D - D I S K D R I V E C O N F I G U R A T I O N E R R O R
drive type. Shut down the computer, remove the hard drive (see "Hard Drive"
on page 129), and boot the computer from a CD. Then, shut down the
computer, reinstall the hard drive, and restart the computer. Run the Hard
Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 87).
A R D D I S K D R I V E C O N T R O L L E R F A I L U R E
H -
to commands from the computer. Shut down the computer, remove the hard
drive (see "Hard Drive" on page 129), and boot the computer from a CD.
Then, shut down the computer, reinstall the hard drive, and restart the
computer. If the problem persists, try another drive. Run the Hard Disk Drive
tests in the Dell Diagnostics (see "Dell Diagnostics" on page 87).
A R D D I S K D R I V E F A I L U R E
H -
from the computer. Shut down the computer, remove the hard drive (see
"Hard Drive" on page 129), and boot the computer from a CD. Then, shut
down the computer, reinstall the hard drive, and restart the computer. If the
problem persists, try another drive. Run the Hard Disk Drive tests in the Dell
Diagnostics (see "Dell Diagnostics" on page 87).
H A R D - D I S K D R I V E R E A D F A I L U R E
down the computer, remove the hard drive (see "Hard Drive" on page 129),
and boot the computer from a CD. Then, shut down the computer, reinstall
the hard drive, and restart the computer. If the problem persists, try another
drive. Run the Hard-Disk Drive tests in the Dell Diagnostics (see "Dell
Diagnostics" on page 87).
I N S E R T B O O T A B L E M E D I A
nonbootable media, such as a floppy disk or CD. Insert bootable media.
I N V A L I D C O N F I G U R A T I O N I N F O R M A T I O N
A memory module may be loose. Reinstall the memory
—
The operating system is unable to carry out the
—
The hard drive does not respond to commands
—
—
The operating system is trying to boot to
—
The computer cannot identify the
—
The hard drive does not respond
0 —
The hard drive may be defective. Shut
- P L E A S E R U N S
The file
—
: \ / : * ? " <
YS T E M S E T U P
Troubleshooting
99