Table of Contents
Advertisement
Windows NT Systems
Remove PC cards from Windows NT systems as follows:
1.
Remove these card types as follows:
T
Modems and ATA drive PC cards — press the button on the side of
the slot containing the PC card. A double tone sounds. (Go to step 2.)
T
LAN, Combo cards, or SCSI cards — press the Power button on the
side of the MiniDock to power off the NEC Versa. Press the button
on the side of the slot containing the PC card.
2.
Pull the card firmly out of the slot.
CONNECTING EXTERNAL DEVICES
See the following sections for instructions on connecting external devices to
the MiniDock.
External Monitor
You can add a standard external monitor to your MiniDock. You need a
display signal cable (usually provided with the monitor). One end of the
cable must have a 15-pin connector for the system.
Follow these steps to connect an external monitor to the MiniDock.
1.
Check that the docked NEC Versa is in Suspend mode or powered off
and the monitor power switch is turned off.
NOTE
off while the monitor is being connected. Otherwise, the system
does not recognize the monitor type.
2.
Connect the cable to the monitor.
The docked NEC Versa must be in Suspend mode or powered
Adding Options and Connecting Peripherals 4-7
Advertisement
Table of Contents
