Preparing The Nec Versa For Docking; Main Power Switch - NEC VERSA MINIDOCK 6000 Service Manual

Figure 2-2 Main Power Switch
Disconnecting the power cable, turning off
power by pressing the main Power switch, or ex-
periencing a power outage while running the
MiniDock and NEC Versa can result in a system
crash.

Preparing the NEC Versa for Docking

Follow the procedure given next to prepare the NEC Versa for docking.
Set NEC Versa power for your system as follows.
1.
T
If you have a Plug and Play NEC Versa, you can either put your sys-
tem into Suspend mode or leave it in full Operation mode for docking.
For example, an NEC Versa with Windows 95 running is a Plug and
Play system.
T
If you have a non-Plug and Play system, turn off system power before
docking. Systems running Windows for Workgroups or Windows NT
do not support Plug and Play.
! CAUTION
NOTE: Make sure your system is in the
appropriate mode for docking.
Setup and Operation 2-3