Section 2 Setup And Operation; Unpacking The System; Hardware Setup; Connecting The Ac Adapter - NEC VERSA 6000 Series Service Manual

Section 2
Setup and Operation
This section provides setup and operation information for the NEC Versa 6000 series sys-
tem (including cabling, power-on verification and using Auto Setup).

UNPACKING THE SYSTEM

Find an area away from devices that generate strong magnetic fields (electric motors,
transformers, etc.). Place the shipping carton on a sturdy surface and carefully unpack the
system. The carton contents include the system, AC adapter, AC power cord, battery, soft-
ware diskettes, and user documentation.

HARDWARE SETUP

When connecting power and signal cables, do the following.
1. The power switch turns the system on or off. Slide the switch right to turn it on,
slide the switch again to turn it off.
Connect the AC adapter cable to the power port on right side of your NEC Versa
2.
6000.
3. Plug one end of the AC power cable into the AC adapter and the other end into a
properly grounded 120- or 240-volt wall outlet.
Figure 2-1 Connecting the AC Adapter