NEC VERSA 2205C Manual page 61

MESSAGE
Non-system disk or
disk error; replace
and press any key
when ready
No boot device
available – press F1
to run Auto Setup
Invalid configuration
information – run
Setup program
Real time clock
failure
Time-of-day not set –
run Setup program
Fixed disk
configuration error
Fixed disk failure
POST Error Messages
WHAT TO DO
Remove the diskette from drive A and press any
key to start the system from the hard disk.
Or, insert a bootable diskette in drive A and press
any key.
Press F1 to start Auto Setup. Change the hard
disk type to the correct setting. Exit and save
Auto Setup.
Or, turn off the system and check to see that the
hard disk is properly installed.
One or more system configuration parameters
are not properly set. Press F1 to start Auto Setup,
set them correctly, exit, and save to update
the parameters.
Set time and date using Auto Setup. Exit and save
to update the parameters.
Set the time and date using Auto Setup. Exit and
save to update the parameters.
Start Auto Setup. Exit and save to update the
parameters. Turn the system off and check to see if
the hard disk is installed properly.
Insert a bootable diskette in the diskette drive and
press Ctrl+Alt+Del to start the system from diskette.
The hard disk might need repair.
Press F1 to start Auto Setup. Exit and save to
update the parameters.
Turn the system off and check to see if the hard disk
is inserted properly.
Insert a bootable diskette in the diskette drive and
press Ctrl+Alt+Del to start the system from diskette.
The hard disk might need repair.
Solving Problems 5-5