NEC VERSA 2205C Manual page 32

4. Install the memory card as follows.
Align the memory card connector with the connectors
in the system. (The card fits in either slot.)
Insert the card connector by sliding it into the system
connector. Press the card to make sure it is securely
seated.
Replace the memory compartment cover.
5.
Run Auto Setup to check the new configuration. Auto
6.
Setup should show a blinking arrow next to the extended
memory field. The new value should reflect the increase
in memory. (Refer to "Using Auto Setup" in the online
Advanced Topics.) If it does not verify, make sure the
memory card is properly seated in the slot.
2-10 Learning to Use the Hardware
Inserting an optional memory card