Network Type And/Or Workgroup - NEC POWERMATE 2000 - RELEASE NOTES 01-2001 Release Note

Click the
3.
loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
Highlight
4.
appears asking for confirmation to continue.
5. Click Yes
disappear from the Configuration display.
Repeat steps 4 and 5 to remove the NetBEUI Protocol.
6.
In the Configuration tab display, click
7.
8. Highlight
there is a DHCP server on the network, click
Change the path in the window to
9.
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
10. Click Close
11. Fill in the
address" area.
Click the
12.
Click the
13.
14. Click the
Click the
15.
Click
16. OK
Changing Network Settings on Systems with the Windows 2000 Operating
System
All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
!
enable a different network protocol
!
disable unneeded protocols for enhanced system performance
!
add or change network, domain, and gateway information.
The following procedures describe how to enable TCP/IP and how to provide network, domain,
and gateway information. (If a different protocol is enabled, the menu choices might differ from
those described in the procedure.)

Network Type and/or Workgroup

Use the following procedure to set up a network type and/or workgroup.
1. From the Windows desktop, click
and Dial up Connections
Click the
2.
From the System Properties box, click the
3.
Wizard launches.
4 NEC PowerMate 2000 Series Release Notes
tab. In the Configuration display, the following protocols are
Configuration
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink NetBIOS lines
Microsoft and then TCP/IP
C:\I386
. The Microsoft TCP/IP Properties Box appears.
IP Address , the Subnet Mask
tab and enter the host and domain name in the DNS display.
DNS
tab and change the Computer Name if appropriate.
Identification
WINS tab and enter the WINS address if appropriate.
tab and enable IP forwarding if appropriate.
Routing
. When prompted to restart the system, click
Start
.
hyperlink in the right window.
Network Identification
and click
Remove
. Highlight
Add Protocol
and click OK . The TCP/IP Setup window appears. If
Yes ; otherwise click
. Click . The Network window appears.
Continue
, and the Default Gateway
.
Yes
on the taskbar, point to Settings
button. The Network Identification
Network ID
. A warning window
and click .
Add
No .
in the "Specify an IP
, and click Network