Changing Network Settings On Systems With Windows 2000; Network Type And/Or Workgroup - NEC POWERMATE CT - RELEASE NOTES 2000 Release Note

Click the
3.
loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
4. Highlight
appears asking for confirmation to continue.
Click
5. Yes
disappear from the Configuration display.
Repeat steps 4 and 5 to remove the NetBEUI Protocol.
6.
In the Configuration tab display, click
7.
Highlight
8.
there is a DHCP server on the network, click
Change the path in the window to
9.
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
10. Click Close
Fill in the
11.
address" area.
12. Click the
Click the
13.
Click the
14.
15. Click the
Click
16. OK

Changing Network Settings on Systems with Windows 2000

All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
T
enable a different network protocol
T
disable unneeded protocols for enhanced system performance
T
add or change network, domain, and gateway information.
The following procedures describe how to enable TCP/IP and how to provide network, domain,
and gateway information. (If a different protocol is enabled, the menu choices might differ from
those described in the procedure.)

Network Type and/or Workgroup

Use the following procedure to set up a network type and/or workgroup.
From the Windows desktop, click
1.
and Dial up Connections
2. Click the
From the System Properties box, click the
3.
Wizard launches.
4 NEC PowerMate CT Release Notes
tab. In the Configuration display, the following protocols are
Configuration
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink NetBIOS lines
and then
Microsoft TCP/IP
C:\I386
. The Microsoft TCP/IP Properties Box appears.
, the Subnet
IP Address Mask
DNS tab and enter the host and domain name in the DNS display.
tab and change the Computer Name if appropriate.
Identification
tab and enter the WINS address if appropriate.
WINS
Routing tab and enable IP forwarding if appropriate.
. When prompted to restart the system, click
Start
.
Network Identification hyperlink in the right window.
and click Remove
. Highlight
Add Protocol
and click . The TCP/IP Setup window appears. If
OK
Yes ; otherwise click
. Click . The Network window appears.
Continue
, and the
Default Gateway
.
Yes
on the taskbar, point to
Settings
button. The Network Identification
Network ID
. A warning window
and click .
Add
No .
in the "Specify an IP
, and click
Network