Changing Network Settings On Systems With Windows 2000; Network Type And/Or Workgroup; Tcp/Ip Setup - NEC POWERMATE ES - RELEASE NOTES 2000 Release Notes

Change the path in the window to
9.
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
Click
10. Close
Fill in the
11.
address" area.
12. Click the
Click the
13.
Click the
14.
15. Click the
Click
16. OK

Changing Network Settings on Systems with Windows 2000

All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
T
enable a different network protocol
T
disable unneeded protocols for enhanced system performance
T
add or change network, domain, and gateway information.
The following procedures describe how to enable TCP/IP and how to provide network, domain,
and gateway information. (If a different protocol is enabled, the menu choices might differ from
those described in the procedure.)

Network Type and/or Workgroup

Use the following procedure to set up a network type and/or workgroup.
From the Windows desktop, click
1.
and Dial up Connections
2. Click the
3. From the System Properties box, click the
Wizard launches.
4. Follow the instructions to set up your network type and/or workgroup. Get this information
from your system administrator.
When you have completed the wizard setup, click
5.
reboot this computer for the changes to take effect," click
At the System Properties screen, click
6.
7. Click Yes

TCP/IP Setup

Use the following procedure to set up TCP/IP.
From the Windows desktop, click
1.
and Dial up Connections
2. Click Add Network Components
4 NEC PowerMate ES Series Release Notes
C:\I386
. The Microsoft TCP/IP Properties Box appears.
, the Subnet
IP Address Mask
DNS tab and enter the host and domain name in the DNS display.
tab and change the Computer Name if appropriate.
Identification
tab and enter the WINS address if appropriate.
WINS
Routing tab and enable IP forwarding if appropriate.
. When prompted to restart the system, click
Start
.
Network Identification hyperlink in the right window.
to restart your system.
Start
.
.
. Click . The Network window appears.
Continue
, and the
Default Gateway
.
Yes
on the taskbar, point to
Settings
Network ID button. The Network Identification
. At the message, "You must
Finish
OK .
.
OK
on the taskbar, point to
Settings
in the "Specify an IP
, and click
Network
, and click
Network