Tcp/Ip Setup; Tcp/Ip Configuration For Dns; Running Windows Setup In Smart Restore (Windows 98Se Only) - NEC POWERMATE 2000 - RELEASE NOTES 01-2001 Release Note

Follow the instructions to set up your network type and/or workgroup. Get this information
4.
from your system administrator.
5. When you have completed the wizard setup, click
reboot this computer for the changes to take effect," click
6. At the System Properties screen, click
Click
7. Yes

TCP/IP Setup

Use the following procedure to set up TCP/IP.
From the Windows desktop, click
1.
and Dial up Connections
Click
2. Add Network Components
From the Windows Optional Network Components Wizard, highlight "Networking
3.
Services," then click the
Check the box for "Simple TCP/IP Services." Click
4.
At the Windows Optional Networking Components Wizard, click
5.
At the instruction to insert the Disc labeled "Windows 2000," click
6.
7. At the Files Needed box, change the "Copy files from" information to
8. Reboot your system for the changes to take effect.

TCP/IP Configuration for DNS

Windows 2000 has an extensive Help file. Use the Windows 2000 help to set up DNS.
Reinstalling Service Pack 6a on Systems with the Windows NT Operating
System
Any time you change the state of a system with Windows NT, such as when you install a new
protocol, device, or service, you must reinstall Service Pack 6a. Reinstalling Service Pack 6a
updates all essential files for the new system configuration. Service Pack 6a is on the NEC
Application and Driver CD that comes with your computer.
Use the following steps to reinstall Service Pack 6a.
Insert the NEC Application and Driver CD into the CD-ROM drive.
1.
Double click
2.
3. At the Windows NT setup screen, check mark the License agreement to start the
installation.
When the installation is done, remove the NEC Application and Driver CD. Click
4.

Running Windows Setup in Smart Restore (Windows 98SE only)

If your system has the Microsoft Windows 98SE operating system and you use the Smart
Restore process to run the Windows Setup option, you also need to restore factory settings for
keyboard and power functions. To restore the settings, insert the NEC PowerMate 2000 Series
Application and Driver CD and run the Keyboard Wakeup & Power button "Stand by button"
update. This update restores the factory settings for your keyboard and power button functions.
to restart your system.
Start
.
.
Details button.
Service Pack 6a for Windows NT
Finish . At the message, "You must
.
OK
OK .
on the taskbar, point to
.
OK
.
NEC PowerMate 2000 Series Release Notes 5
, and click
Settings Network
.
Next
.
OK
C:\i386 . Click OK .
Restart
.