Changing Network Settings On Systems With The Microsoft Windows 2000 Operating System; Network Type And/Or Workgroup - NEC POWERMATE ES - RELEASE NOTES 2001 Release Note

2. Double click the
3. Click the
loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
Highlight
4.
appears asking for confirmation to continue.
Click
5. Yes
disappear from the Configuration display.
6. Repeat steps 4 and 5 to remove the NetBEUI Protocol.
7. In the Configuration tab display, click
Highlight
8.
there is a DHCP server on the network, click
9. Change the path in the window to
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
Click
10. Close
Fill in the
11.
address" area.
12. Click the
Click the
13.
Click the
14.
Click the
15.
16. Click OK
Changing Network Settings on Systems with the Microsoft Windows 2000
Operating System
All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
!
enable a different network protocol
!
disable unneeded protocols for enhanced system performance
!
add or change network, domain, and gateway information.
The following procedures describe how to enable TCP/IP and how to provide network, domain,
and gateway information. (If a different protocol is enabled, the menu choices might differ from
those described in the procedure.)

Network Type and/or Workgroup

Use the following procedure to set up a network type and/or workgroup.
From the Windows desktop, click
1.
and Dial up Connections
2. Click the
4 NEC PowerMate ES Series Release Notes
Network icon in the Control Panel window.
Configuration tab. In the Configuration display, the following protocols are
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink NetBIOS lines
and then
Microsoft TCP/IP
C:\I386
. The Microsoft TCP/IP Properties Box appears.
, the Subnet
IP Address Mask
DNS tab and enter the host and domain name in the DNS display.
tab and change the Computer Name if appropriate.
Identification
tab and enter the WINS address if appropriate.
WINS
tab and enable IP forwarding if appropriate.
Routing
. When prompted to restart the system, click
Start
.
Network Identification hyperlink in the right window.
and click
Remove
Add . Highlight Protocol
and click . The TCP/IP Setup window appears. If
OK
; otherwise click
Yes
. Click Continue . The Network window appears.
, and the
Default Gateway
Yes .
on the taskbar, point to
Settings
. A warning window
and click Add .
.
No
in the "Specify an IP
, and click
Network