Status Leds - SMC Networks 6900FSC Installation Manual

A T
BOUT THE IGER

Status LEDs

The LEDs, which are located on the front panel for easy viewing,
are shown below and described in the following table.
Figure 1-4. Port and System LEDs
LED
Power
RDP
Mgmt
RJ-45 Ports
Link
Act*
FDX*
FC*
* Use the Mode Select button to select the LED display mode.
1-4
S 10/100
WITCH
Port and System Status LEDs
Condition
On
On
Off
On
On
Green
Yellow
Flashing
On
On
Off
On
Status
Switch is receiving power.
Redundant power is on, and the RPU is in
backup or active mode.
Redundant power is off or has failed.
Agent is operational.
Port has established a valid network
connection.
Valid 10 Mbps connection.
Valid 100 Mbps connection.
Port has been partitioned due to an
abnormal network condition, or manually
disabled.
Traffic is passing through the port.
Port is operating at full duplex.
Port is operating at half duplex.
Flow control enabled.