M
N
AKING
ETWORK
(MDI-X). Since network cards do not cross their internal wiring to
make a connection, PCs can be connected to these ports with
straight-through cable.
10BASE-T/100BASE-TX hubs and switches, on the other hand, may
have either crossover (MDI-X) or straight-through (MDI) ports. For
this reason, the type of cable used to connect these devices to the
TigerSwitch is determined by the port on the other device, as
shown in the table below. (See Appendix B for further
information on cabling.)
If the port on the
switch is...
Crossover (x)
Crossover (x)
Straight-through (=)
Straight-through (=)
4-2
C
ONNECTIONS
Crossover/Straight-Through Wiring Requirement
And the port on the
other device is...
Crossover
Straight-through
Crossover
Straight-through
Caution: Do not plug a phone jack connector into an
RJ-45 port. This will damage the switch. Use only
twisted-pair cables with RJ-45 connectors that conform to
FCC standards.
Then use...cable
Crossover
Straight-through
Straight-through
Crossover