Table of Contents
Advertisement
In-Band Access
You can access the management agent in the SMC6824MPE switch from
anywhere within the attached network using Telnet, a web browser, or other
network management software tools. However, you must first configure the
switch with a valid IP address, subnet mask, and default gateway. If you have
trouble establishing a link to the management agent, check to see if you have
a valid network connection. Then verify that you entered the correct IP
address. Also, be sure the port through which you are connecting to the
switch has not been disabled. If it has not been disabled, then check the
network cabling that runs between your remote location and the switch.
Note: The management agent accepts up to four simultaneous Telnet
sessions. If the maximum number of sessions already exists, an
additional Telnet connection will not be able to log into the system.
Stack Troubleshooting
If a stack fails to initialize or function, first check the following items:
•
Check that all stacking cables are properly connected.
•
Check if any stacking cables appear damaged.
•
Check that only one Master Select button is pressed in.
•
Check that all switches in the stack are powered on.
After checking all items, reboot all the switches in the stack. If the problem is
still not resolved, contact your dealer for assistance.
I
-B
A
N
AND
CCESS
A-3
Advertisement
Table of Contents
Troubleshooting
