Structural Concepts Harmony HMBC2 User Manual page 14

Cleaning Schedule (To Be Performed by Store Personnel)
F REQU ENC Y
Daily
Daily
Daily
Daily
Daily
Weekly
Quarterly
Harmony® User Manual
IN ST R U CT I ON S
Glass Surfaces: Clean glass surfaces and shelves with household or commercial glass cleaner.
Exterior Panels: Wipe off all surfaces with warm water and mild soap solution and non-abrasive
cloth.
Decks: Wipe off decks with a moist cloth dipped in mild soap and water solution..
Acrylic Surfaces:
• Clean: Use a soft, clean cloth dipped in a solution of warm water and a small amount of mild
liquid soap. Apply light pressure while wiping away all smudges and residue.
• Rinse: Use pure water in a spray bottle to rinse.
• Dry: Use non-abrasive clean cloth.
• Polishing: Buff with a light coat of automobile paste wax or plastic cleaner/polish.
• Scratches: Use high-quality buffing compound. Carefully follow instructions.
• Never use window or household cleaning products.
Stainless Steel Surfaces:
• Wash with a solution of hand dish-washing liquid detergent and water or a solution of baking
soda and water. Rinse and polish dry with a soft cloth.
• Never use scouring powders or steel wool as they will scratch stainless steel.
• Brighten by polishing with a cloth dipped in vinegar or in ammonia; sprinkle baking soda on a
sponge and rub gently, rinse. Polish dry with soft cloth.
• Remove streaks or heat stains from stainless steel by rubbing with club soda..
Magnetic Condensing Coil Filter:
• This filter helps prevent dust particles from entering condenser coil.
• It is accessible at the air intake side of the case.
• Magnetic condenser coil filter is dishwasher safe; remove from case and use a rag or soft-
bristled brush to wipe off excess dust particles from filter. Run in normal dishwasher cycle.
Remove from dishwasher
• Dry with a soft cloth or allow to air dry. Replace in case.
Under Case Cleaning:
• Remove lower front and rear panels. Unlock caster and lower to floor.
• Slide the case out of the current position, and slide the condenser package out from under the
case.
• Use a vacuum with brush to remove all dust, dirt, food particles, or residue from underside of
the case.
• Place the case back in position and replace the front and rear panels.
14