CODELOCKS CL50 Instructions

CODELOCKS UK
HEADQUARTERS
CL5O
Tel: +44 (0) 1635 239645
Fax: +44 (0) 1635 239644
sales@codelocks.com
www.codelocks.com
Helpline, service & spares
Freephone: 0800 393 405
CODELOCKS INC US
Tel: +1 714 979 2900
Fax: +1 714 979 2902
sales@codelocks.us
www.codelocks.us
Helpline, service & spares
Toll free: 1.877.codelock
CODELOCKS
(Australia) PTY LTD
Tel: +61 2 9882 1009
Fax: +61 2 9882 6030
sales@codelocks.com.au
www.codelocks.com.au
Helpline, service & spares
Toll free: 1800 052 131
www.codelocks.com
DIAGNOSTICS
1
On latch locks only. The outside knob and inside handle
retract the latch when turned TOWARDS the door frame.
The spindle is positioned at the wrong angle.
2
The knob will not turn after entering the original code.
The code does not match the card.
3
The knob will not turn after entering a newly changed code.
One or more of the code tumblers are the wrong
way around.
4
The latchbolt does not move smoothly in and out.
The lock is installed incorrectly.
5
The inside and outside knobs do not return easily to the
centre position after use.
The spindle is too long for the door thickness.
6
The inside handle does not retract the latch.
The spindle is too short for the door thickness.
7
The inside lever handle does not return to the upright
position after operating.
The lever return spring is broken.
8
The latch does not engage and so the door remains
unlocked after use.
The latch is not entering the strike.
For full information on all mechanical and electronic locks in our range visit www.codelocks.com
Use these simple guides to diagnose any issues
you may have with your lock.
Refer to the installation instructions. Remove lock from door and reposition the
spindle as shown in the instructions. On hold open locks ensure that the blue
handing screw on the lever handle plate is in the correct hole.
Remove the locks from the door, turn the lock over and check
that the coloured tumblers correspond with the code on the card.
NB: The 'C' tumbler is not coloured - but MUST start every code.
Re-read the code change instructions and check that the square notches
on the tumblers face to the outside edge of the lock with the square edge
on top.
Check that the lock is square on the door and positioned accurately over
the latch. Check that the latch is positioned horizontally and parallel to the
door surfaces.
The spindle must not project more than 30mm (1 / ") into the inside handle.
3
16
If it does then it will be trapped between the front and back handles and
prevent them moving easily. The spindle must be shortened.
The spindle must project from the inside face of the door by at least 8mm (
so as to engage the handle. The spindle may have been cut too short during
installation. Call the helpline to obtain a longer spindle.
Replacement spring required.
Your door or frame may have warped since the lock was installed. Check that the
latchbolt is lined up with the strike aperture and adjust the position of the strike
as necessary. Make sure the deadlocking plunger cannot enter the strike
aperture alongside the latchbolt when the door is closed.
Code Change
Instructions
CL5O
/ ")
5
16
Mini Push Button Lock