Advertisement
Write down the model, type and serial number. Find these numbers on a label on the middle back side of the vacuum cleaner. Refer to these numbers when ordering parts and accessories or if service is needed.
Registration: To register your product visit www.eureka.com and click on the 'Register Your Product' link in the top right corner.
Inspection: Carefully unpack and inspect your new Eureka vacuum cleaner for shipping damage. Each unit is tested and thoroughly inspected before shipping. For instructions regarding any shipping damage, call Eureka Customer Service HELPLINE 1-800-282-2886 immediately.
For filter maintenance instructions, see section "How to maintain dust cup and filters"
Press the quick release button on the hand vacuum grip and insert the handle. Make sure it is all the way inserted into the body of the vacuum.
Attach the motorized floor nozzle by inserting it into the opening at the bottom of the dust cup. Press firmly to secure in place.
Wrap cord around the upper and lower cord wraps on the back of the vacuum. Clip plug onto the cord.
Tilt vacuum up into its upright position. Click!
Plug power cord into the outlet.
Turn on power switch on the front of the hand vacuum.
Step on nozzle and tilt vacuum to release from its upright position.
Turn hand vacuum 180° as shown for better reach under furniture.
Floor nozzle may be used with the hand vacuum to clean wider surfaces.
To attach floor nozzle to the hand vacuum, insert it into the opening at the bottom of the hand vacuum. Press firmly to secure in place.
Flip down the built-in 2-in-1 accessory to use the crevice tool and/or flip down the dusting brush attachment. When done flip both back up into their storage position.
Turn vacuum off. Then, unplug the vacuum
To remove dirt from the dust cup and filter, hold vacuum vertically. Press dust cup latch to release the dust cup as shown.
Gently remove the filter as shown.
Empty dust cup into waste container.
Replace filter. Attach dust cup to vacuum. Make sure dust cup is correctly secured.
Make sure vacuum is turned off and power cord is unplugged.
Problem | Solution |
Motor will not start |
|
The unit does not vacuum effectively |
|
Dust blows out of air vents |
|
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER
To reduce the risk of fire, electric shock, or injury:
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Motor
Do Not Oil the motor at any time. The bearings are permanently lubricated and sealed.
Obtaining warranty service:
To obtain warranty service you must contact the Eureka Service Team, toll free, at 1-800-282-2886 or email customerserviceusa@midea.com, to discuss the warranty claim and procedures to be followed. All warranty claims must include submission of proof-of-purchase documentation. For additional information, you may also visit www.eureka.com.
Midea America Corp.
300 Kimball Ave
Parsippany, NJ 07054 USA
If you have questions about your new vacuum, please contact our customer service HELPLINE at 1-800-282-2886. We're here to help!
www.eureka.com
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the NES310 Series and is the answer not in the manual?
Questions and answers