Warnings And General Precautions; Product Description - Nice Yubii On/Off-Control2 Instructions And Warnings For Installation And Use

1

WARNINGS AND GENERAL PRECAUTIONS

• Any use other than that specified herein or in environmental conditions other than those stated in this manual is to be consid-
ered improper and is strictly forbidden!
• Important instructions: keep this manual in a safe place to enable future product maintenance and disposal procedures.
• All installation and connection operations must be performed exclusively by suitably qualified and skilled personnel with the
unit disconnected from the mains power supply.
• This manual contains important instructions and warnings for personal safety. Read carefully all parts of this manual. If in
doubt, suspend installation immediately and contact Nice Technical Assistance.
• The product packaging materials must be disposed of in full compliance with local regulations.
• Never apply modifications to any part of the device. Operations other than those specified can cause malfunctions. The manufacturer declines
all liability for damage caused by makeshift modifications to the product.
• Never place the device near the sources of heat or expose to naked flames. These actions can damage the product and cause malfuntions.
• This product isn't intended for use by people (including children) with reduced physical, sensory or mental capabilities or who lack experience
and knowledge, unless they are supervised by a person responsible for their safety.
• Make sure children don't play with the product.
• The device is designed to operate in an electrical home installation. Faulty connection or use can result in a fire or electric shock.
• Even when the device is turned off, voltage can be present at its terminals. Any maintenance introducing changes to the configuration of con-
nections or the load must be always performed with a disabled fuse.
2

PRODUCT DESCRIPTION

On/Off-Control2 is designed to be installed in standard wall switch boxes or anywhere else where it's necessary to control electric devices.
On/Off-Control2 enables controlling connected devices either through the Z-Wave
to it. On/Off-Control2 is equipped with active power and energy consumption metering functionality.
The device monitors load power consumption, loads energy consuption and mains voltage values.
Data is transmitted through the Z-Wave
Advanced microcontroller ensures maximum accuracy measurements and resolution (+ / - 5% for loads above 10 W).
2.1 - Main features of On/Off-Control2
• Working as an extension unit
• Compatible with any Z-Wave
• Supporting the protected mode (Z-Wave
• Controlled by an advanced microcontroller
• Having an active power and energy metering functionality
• Working with momentary and toggle types of switches
• Possible to be installed in wall switch boxes of dimensions consistent with applicable regulations
• Measuring the active power of the load, energy consumed and voltage of the network
• Compatible with the following:
- Conventional incandescent lamps (including halogen)
- LED compact bulbs, CCFL compact fluorescent lamps
- Electronic power supplies (for LEDs, fluorescent lamps, halogen lamps)
- Halogen bulbs with magnetic transformers
- Resistive loads
2.2 - Full compatibility with Z-Wave Plus
This device can be used with all devices accredited with the Z-Wave
by other manufacturers. All non-battery operated devices within the network act as repeaters to increase reliability of the network.
The device is a Security Enabled Z-Wave
the product.
2
Network to the controller.
®
or Z-Wave Plus Controller
® ®
® network security mode) with AES-128 encryption
devices
®
® Plus product and a Security Enabled Z-Wave
® Plus network or throught a wall switch connected directly
® Plus certificate and is compatible with such devices produced
® Controller must be used to fully utilize