ITech IT6723 User Manual page 5

ООО "Техэнком" Контрольно-измерительные приборы и оборудование
Environmental conditions
Regulation tag

If the equipment is not used in the manner specified by the manufacturer,
its protection may be damaged.

Always use dry cloth to clean the equipment housing. Do not clean the
inside of the instrument.

Do not block the air vent of the equipment.
The IT6700 series power supply can only be used indoors or in low
condensation areas. The following table shows general environmental
requirements for this instrument.
Environmental conditions
Operating temperature
Operating humidity
Storage temperature
Altitude
Installation category
Pollution degree
NOTE
In order to ensure the accuracy of measurement, it is recommended to operate the
instrument half an hour after start-up.
Copyright © Itech Electronic Co., Ltd.
Series IT6700 User's Manual
Requirement
0°C - 40°C
0°C - 40°C
20% - 80% (non condensing)
-20°C - 70 °C
Operating up to 2,000 meters
II
Pollution degree 2
The CE tag shows that the product complies
with the provisions of all relevant European
laws (if the year is shown, it indicates that the
year when the design is approved).
This instrument complies with the WEEE
directive (2002/96/EC) tag requirements.
This attached product tag shows that the
electrical/electronic product
discarded in household waste.
This symbol indicates that no danger will
happen or toxic substances will not leak or
cause damage in normal use within the
specified period. The service life of the
product is 10 years. The product can be
used safely within the environmental
protection period; otherwise, the product
should be put into the recycling system.
www.tehencom.com
cannot be
iii