Adjustments Before Operation; Power; Eco Mode; Setting The Clock - Aiwa XR-EM50 Operating Instructions Manual

ADJUSTMENTS BEFORE OPERATION

TAPE,
TUNER/BAND,
AUX, CD

POWER

6STANDBY/ON
s
ECO
DISPLAY
Power
Turning the unit on
Press POWER 6 STANDBY/ON (POWER on the remote
control).
Alternatively, press TAPE, TUNER/BAND, AUX or CD. Playback
will start automatically if a disc or tape is loaded.
Turning the unit off
Press POWER 6STANDBY/ON again.
The unit goes into standby.
To change the display window brightness (Dimmer)
Hold down DISPLAY (hold down SHIFT and press DISPLAY
on the remote control) for about 4 seconds while the power is
on.
Repeat the above to restore the brightness.
CLOCK
f,g
TONE
SET
SHIFT

ECO mode

Reduces power consumption in standby mode with the following
operations.
Press ECO.
Each press of the button changes the mode as follows;
ECO ON: Power economizing mode is activated.
When the unit turns off, everything on the display clears and
only the red indicator above POWER lights to show that the
power is being supplied.
ECO OFF: Power economizing mode is canceled.
When the unit turns off, the clock display appears.
Initial mode is ECO OFF.
Standby power consumption
ECO ON: 0.7 W
ECO OFF: 10.7 W

Setting the clock

1 Hold down SHIFT and press CLOCK on the remote
control.
DISPLAY
When the unit is turned off, you can also press SET.
2 Within 6 seconds, press f or g to set the
CD,
time.
TUNER/BAND,
TAPE, AUX,s Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
f,g
units.
3 Press SET.
The time display stops flashing and the clock starts from
00 seconds.
When setting the clock on the unit in stop mode, hold down
s and press g in step 1. After setting the time in step 2,
press TONE in step 3.
To display the time while the power is on
Hold down SHIFT and press CLOCK on the remote control.
The time will be displayed for 6 seconds.
To switch to the 24-hour standard
Display the time and press s within 6 seconds.
With each press, the clock alternates between 12- and 24-
hour standard time.
Tip:
In the 12-hour standard, "AM12:00" indicates midnight and
"PM12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Reset the clock.
En
7