Adjustments Before Operation - Aiwa XR-EM70 Operating Instructions Manual

Main unit: rear
1
2
3
1 AM LOOP jack and FM 75
Plug in the supplied AM and FM antennas.
2 AUX IN jacks
Accept analog sound signals from external equipment.
Connect external equipment using an optional connecting
cable with RCA phono plugs (red plug to R jack, white
plug to L jack). Refer also to the operating instructions
for your equipment.
To switch function to external input, press AUX.
3 SPEAKERS3 terminals
Connect the supplied speaker cords of the supplied
speakers.
4 DIGITAL OUT (OPTICAL) jack
CD digital sound signals can be output through this jack.
Use an optical cable to connect digital audio equipment.
Remove the dust cap from the DIGITAL OUT (OPTICAL)
jack. Then connect an optical cable plug to the DIGITAL
OUT (OPTICAL) jack.
5 AC power cord

ADJUSTMENTS BEFORE OPERATION

dTAPE,
TUNER/BAND,
AUX, ECD
4
SET
ECO/DIMMER
POWER
6STANDBY/ON
5
Power
Turning the unit on
terminals
Press POWER 6 STANDBY/ON (POWER on the remote
control).
Alternatively, press TAPE, TUNER/BAND, AUX or CD. Playback
will start automatically if a disc or tape is loaded.
Turning the unit off
Press POWER 6STANDBY/ON again.
The unit goes into standby.
To adjust the input level of the equipment
connected to the AUX IN jacks
Press AUX to select the function of external equipment
connected to the AUX IN jacks, then press f or g
repeatedly.
The input level can be adjusted to "NORMAL" or
"–6 dB".
POWER
f,g
CLOCK
VOLUME
f
SHIFT
Volume
Turn VOLUME (press VOLUME (+/–) on the remote
control).
Adjust from 0 (minimum) to 49 and MAX (maximum).
Tip:
Volume level setting is retained during power-off standby. If
the unit is turned off with the volume set to 36 or higher, it is
automatically turned down to 35 the next time the unit is turned
on.
To change a source name in the display of the AUX
function
Hold down AUX and press POWER while the power is on.
AUX VIDEO TV
SET
VOLUME
(+/–)
En
g
7