COVANA EVO Replacement Procedure

PRODUCT MODELS
● Evolution Cover
● Oasis Cover
PURPOSE OF THE REPAIR PROCEDURE
This repair procedure should be performed if the chain tensioner
needs to be replaced or ajusted, or if a motor jack has to be replaced
on the Evolution or Oasis spa cover.
PREPARATION
● The cover must be closed.
● Gather the required tools, as seen in the table at right.
● Make sure the parts kit is complete and that parts have not
been damaged during transport. Call your local dealer if parts
need to be replaced.
Do not use power tools, some parts are fragile and may break under too much torque.
This procedure must be performed by a certified Covana installer.
Keep the key out of the key switch socket at all times. The certified Covana installer must keep control of the key during the
repair procedure. Derogation from this directive could cause serious injury or damage the cover.
Motor and non-motor sides identification
Motor
side
STEP BY STEP PROCEDURE
A- REMOVING DEFECTIVE JACK ASSEMBLY
1) Remove the rubber
cap from each
post.
EVO - OASIS ― MOTOR JACK REPLACEMENT PROCEDURE
TOOLS REQUIRED
1/2" socket wrench and spanner
Phillips screwdriver
Flat blade screwdriver or long nose pliers
PARTS KIT NO. 233460
Oasis G3 Motor post assembly 600N
M6-1.0 Panel nut
M8-1.25 x 50 mm button head screw
Chain guide
#10-24 x 1/2" slotted hex washer head screw
Version française à la page 5.
CAUTION
WARNING
2) Remove the four
M6 x 20 mm bolts
and 5/16" painted
metal
Non-Motor
from each post to
side
separate the cover
from
Do not discard !
Leave the bracket
attached to the
sleeve.
3) Remove the 3/8-24
x 1" Allen bolt with
a 7/32" Allen key
from each post.
Do not discard !
Rubber
cap
4) Loosen the Phillips
M6 x 20 mm screw
at the bottom of
each post.
Do not remove
the screw.
image 1
COVANA.COM
Metric Allen keys
washers
its posts.
M6
screw
1/4" nylon
washer
Adjustable wrench
48" long level
Measuring tape
QTY CODE
1 230053
1 202159
2 233731
2 187235
2 203479
image 2
image 3
image 4
1