Continuous Play - Aiwa NSX-MTD9 Operating Instructions Manual

If there is a 4-second or longer blank between each track, a search for the beginning of the current or next track
during playback can be done easily.
When or button is flashing, press to move to the next track or to move to the beginning
of the current track. When of button is flashing, press to move to the next track, or to
move to the beginning of the current track.
The search function may not be able to detect tracks under the following conditions:
• Blanks of less than 4 seconds between tracks
• Noisy blanks
• Long passages of low-end sound
• Low overall recording levels

CONTINUOUS PLAY

After playback on one deck finishes, the tape in the other deck will start to play without interruption.
1 Insert tapes into deck 1 and deck 2.
2 Press TAPE/DECK 1/2 to select the deck to be played back first.
3 Press REV MODE(DECK 2) to select .
4 Press to start playback.
Playback continues until is pressed.
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or
other pointed tool.
To record on the tape again, cover the tab openings with adhesive tape, etc. (On Type II tapes, take care not to cover
the Type II tape detection slot.)
• 120-minute or longer tapes are extremely thin and easily deformed or damaged. They are not recommended.