Aiwa NSX-MTD9 Operating Instructions Manual page 40

5 Press or to designate the tape length.
10 to 99 minutes can be specified.
In a few seconds, the tracks to be recorded on each side of the tape are determined.
• The numbered buttons 0-9 or MULTI JOG are also available to designate the tape length.
Example: When using a 60-minute tape, press 6 and 0.
6 Press REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the lead segment is played through for 10 seconds, and
recording starts. When recording on the front (side A) ends, recording on the back (side B) starts.
To stop recording
Press . Recording and CD play stop simultaneously.
To clear the edit program
Press CLEAR twice so that "EDIT" disappears on the display.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B, and press or repeatedly or turn
MULTI JOG.
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment.
1 Press CD EDIT/CHECK to select side A or B.
2 Press one of the DISC DIRECT PLAY 1-5 to select a disc.
3 Press the numbered buttons on the remote control to select tracks.
A track which has a playing time longer than the remaining time cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than the specified recording time printed on the label.
This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape's
specified recording time after editing, the display shows the extra time (without a minus mark), instead of the time