Continuous Play - Aiwa NSX-A94 Operating Instructions Manual

MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
Press the < or > button during playback referring to the
playback side indicator (< or F) on the display.
For example, when the P button is pressed while P is
displayed, playback of the next track starts.
Music sensor function may not be able to detect tracks under
the following conditions:
Blanks of less than 4 seconds between tracks
Noisy blanks
Long passages of low-end sound
Low overall recording levels
CONTINUOUS PLAY
2
1
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press the TAPE/DECKl/2 button to select
deck to be played back first.
Press the REV MODE button to select =).
Press the 4 b button to start playback.
Playback continues until the N button is pressed.
he
About cassette tapes
* To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
.O
a
<Q
\ ;0>
40
*
Type
II
tape
Tab for side A
detection
slot
\
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type
II
tapes, take care not to
cover the Type
II
tape detection slot.)
120-minute o r longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
('
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system,
ENGLISH 14