Ai Edit Recording - Aiwa NSX-MTD9 Operating Instructions Manual

• Recording does not start, if the erasure prevention tab on either side of the tape is broken off.
• If the leader segment of the tape to be recorded on is longer than that of the original tape, recording on the reverse
side may stop midway through the recording. In this case, dub each side manually following the procedure in
"DUBBING A TAPE MANUALLY".
RECORDING (cont.) pg. 21

AI EDIT RECORDING

The Al edit recording enables CD recording without worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length. If necessary, the order of tracks is rearranged so that
no track is cut short. (Al: Artificial Intelligence)
Al edit recording will not start from a point halfway into the tape. The tape must be recorded from the beginning of
either side.
1 Insert the tape into deck 2, and press DOLBY NR to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out from the unit.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK once.
"EDIT" lights up and "Al" flashes on the display.
When "PRGM" is displayed, press CD EDIT/CHECK again.
4 Press one of the DISC DIRECT PLAY 1-5 to select a disc.