Table of Contents
Advertisement
6.5.1 Network Settings (General)
Web Page: Network Settings
Label on web page: DHCP/Static IP
Parameter name: NETWORK_WAN_SETTINGS_DHCP
Type: Boolean
Default Value: 1 (DHCP)
Notes: 0 = Static; 1 = DHCP
For brevity the following parameters are listed individually. They each take an IP
address expressed in hexadecimal and all but the subnet mask (which defaults to
0xFFFF0000 [255.255.0.0]) default to 0x00000000[0.0.0.0]. These parameters are
ignored except when NETWORK_WAN_SETTINGS_DHCP is disabled (set to 0).
IP Address
Subnet Mask
Default gateway
DNS (primary)
DNS (secondary)
For example, setting the IP address 192.168.1.6 is done like this:
%NETWORK_WAN_SETTINGS_IP%:0xC0A80106
!
Note Well: IP Addresses must be entered as a single hexadecimal number.
In the IP40 configuration file IP addresses in "dotted quad" format will be
rejected by the headset adapter.
The amount of time that the IP40 headset adapter will wait for DHCP responses is
configurable from the configuration file as an integer number between 1 and 600
seconds via the NETWORK_DHCP_CLIENT_TIMEOUT parameter. The default setting
is 3 seconds.
6.5.2 DHCP Options
Web Page: Network Settings
Label on web page: Boot Server
Parameter name: NETWORK_DHCP_CLIENT_BOOT_SERVER
Type: enumeration
Default Value: 2 (Static)
Notes: 0 = "Opt 66": use server found in DHCP Option 66; 1 = "Custom": use server
found in the DHCP Option whose number is found in
NETWORK_DHCP_CLIENT_BOOT_SERVER_OPTION; 2 = "Static": do not use
servers found via DHCP options; 3 = "Custom + Opt 66": If the "custom" DHCP option is
5/29/2009
NETWORK_WAN_SETTINGS_IP
NETWORK_WAN_SETTINGS_SUBNET_MASK
NETWORK_WAN_SETTINGS_GATEWAY
NETWORK_WAN_SETTINGS_DNS1
NETWORK_WAN_SETTINGS_DNS2
Plantronics IP40 Administration Guide
Page 36
Advertisement
Table of Contents
