Configuration Using The Embedded Web Server - Plantronics IP40 Administration Manual

value will follow immediately after the colon and will be expressed as a decimal integer
(with no quotes):
%NETWORK_DHCP_CLIENT_BOOT_SERVER_OPTION%:12345 // integer value in
decimal
%NETWORK_WAN_SETTINGS_IP%:0xC0A80106 // or hexadecimal
If the parameter is a codec priority list, the value following the colon is a comma
separated list of decimal or hexadecimal integers, ending in hexadecimal 0xFF (255
decimal):
%SRV_0_SIP_UA_CODEC_PRIORITY%:0,1,3,4,0xFF
If the type of parameter has any other type of value (a string, IP address, domain name,
or URI), the value following the colon is a double-quoted string value (a value bracketed
by <"> on both sides):
%NETWORK_DHCP_CLIENT_BOOT_SERVER_OPTION%:"string value of
configurable option"
The specific configuration file entries are discussed in more detail in the following
sections under Section 6 "Configuration Reference ".

3.3 Configuration Using the Embedded Web Server

The IP40 has an embedded web server which can be used for individual configuration.
The web server also provides access to the internal logging messages and the ability to
reboot the unit. Before accessing the web server, it is necessary to determine the IP
address of the IP40.
Determine the IP address of the IP40
Since the IP40 has no display, the IP address is rendered to the administrator aurally by
playing the IP address, one digit at time, through the headset. For example, '10.1.7.155'
sounds like "one-zero-dot-one-dot-seven-dot-one-five-five".
Make sure that a headset is plugged into the IP40. Make sure that the IP40 has finished
booting. The power LED will be solid green, the mute button will be unlit, and the
answer/end button will be unlit or solid red. If the Answer/End LED is red (this is typical
if not configured), press and hold the Answer/End button for more than 5 seconds and
the IP address of the unit will be spoken
Error messages maybe accessed in the same way using a brief button press (less than
5 seconds) of the Answer/End button. If the error message played says either "IP
address not found" or "Your network cable is not connected", the administrator needs to
5/29/2009 Plantronics IP40 Administration Guide Page 14