Network Settings Page - Plantronics IP40 Administration Manual

NOTE: Access to the IP40 headset adapter web pages can be disabled by setting
LOCAL_HTTP_SERVER_ACCESS to 0. in configuration file. This setting can not
be accessed from the web interface

6.5 Network Settings Page

By default, the IP40 uses DHCP to fetch an IP address. Once it obtains an initial
address, it can be reconfigured with a static IP address. This is not recommended, but
may be useful in some very specialized environments, such as in a network testing
laboratory. Note that if these parameters are incorrectly configured, the IP40 can be
restored to its factory settings (see the section on Factory Reset) at which point it will
begin using DHCP
again.
5/29/2009 Plantronics IP40 Administration Guide Page 34