Setting A Password - Dell POWERVAULT MD3600F Owner's Manual

Setting a Password

You can configure each storage array with a password to protect it from
unauthorized access. MDSM prompts for the password when an attempt is
made to change the storage array configuration, such as, when a virtual disk is
created or deleted. View operations do not change the storage array
configuration and do not require a password. You can create a new password
or change an existing password.
NOTE:
It is recommended that you use a long password with at least 15
alphanumeric characters to increase security.
To set a new password or change an existing password:
1 Select the relevant storage array and navigate to the AMW for that storage
array. See "Array Management Window" on page 67.
The AMW for the selected storage array is displayed.
2 In the AMW, perform one of these actions:
• Select the storage array in the Logical pane, and then select Storage
ArraySet Password.
• Select the Setup tab, and then click Set a Storage Array Password.
Select the Logical tab, right-click and select Set Password.
•
The Set Password dialog is displayed.
3 If you are resetting the password, type the Current password.
NOTE:
password blank.
4 Type the New password.
5 Re-type the new password in Confirm new password.
NOTE:
exactly the same.
6 Click OK.
NOTE:
You are not prompted for a password when you attempt to change the
storage array configuration in the current management session.
If you are setting the password for the first time, leave the Current
The password in Confirm new password and New password must be
Configuration: About Your Storage Array
75