Page 3
Table of contents Table of contents Safety instructions.......................................... 4 Scope of delivery..........................................5 Assembly.............................................. 6 Technical specifications......................................13 Protecting the environment....................................14 MPS-1000 E-Drum Monitor BD E-Drum Set...
Page 4
Safety instructions Safety instructions DANGER! Risk of injury and choking hazard for children! Children can suffocate on packaging material and small parts. Children can injure themselves when handling the device. Never allow chil‐ dren to play with the packaging material and the device. Always store packaging material out of the reach of babies and small children. Always dispose of packaging material properly when it is not in use.
Page 5
Scope of delivery Scope of delivery Before you assemble your drum set, make sure the contents of package is complete according to the following list. Qty. E-Drum module Millenium MPS-1000 E-drum module stand Hi-hat pad (13", dual zone) Crash pad (15", dual zone, with choke function) Ride pad (18", triple zone, with choke function) Tom pad (10", two zones, mesh head) Tom pad (12", two zones, mesh head)
Page 6
Assembly Assembly Overview Loosen the screws of the individual clamps before assembling. Mount the various elements in the specified sequence. The final positions of the components are shown in the illustration below. ö Hi-hat pad (13", dual zone) 2, 3 Crash pad (15", dual zone, with choke function) Ride pad (18", triple zone, with choke function) Tom pad (10", two zones, mesh head)
Page 7
Assembly Bass drum and tom pads CAUTION! Risk of cuts to the hands from sharp edges during assembly! Tools, screws and components can have sharp edges that can cause cuts during assembly. Pay attention to sharp edges when assembling and screwing the individual parts. Wear protective gloves if necessary. &...
Page 8
Assembly Floor tom Fasten the three floor tom spurs (8) to the tom (9) with the wing nuts of the fastening clamps and hand-tighten them. Align the floor tom spurs (8) according to your needs and then tighten the wing nuts of the fastening clamps evenly. Snare pad Loosen the wing nut of the spurs of the snare stand (10), align it according to your needs and then tighten the wing nut again.
Page 9
Assembly Hi-hat pad Unscrew the wing nut (14) from the bracket (15) and remove the felt washers (16) and the round nuts (18) from the bracket. Place the two felt washers (16), the hi-hat pad (17) and the round nuts (18) on the holder one after the other, as shown in the illustration.
Page 10
Assembly Drum module < Place the drum module (25) on the module plate (26) and screw them together with the supplied screws. Guide the module plate (26) into the drum module holder (27) and then tighten the wing nut of the drum module holder to fix the drum module.
Page 11
Assembly Cymbals > Unscrew the wing nut (28) of the boom cymbal stand (29) and open up the legs. Then tighten the wing nut (28) again. Insert the bracket (30) into the boom cymbal stand (29) as shown in the illustration. Adjust the height of the bracket (30) according to your needs and then tighten the wing nut (31).
Page 12
Assembly Set-up and cabling Set up the stands and pads according to your needs. All drum and cymbal pads are wired with the multiple cable supplied. The plugs are appropriately labelled. The second crash pad is wired to the e-drum module via the additional jack cable. The tension of the mesh heads is relatively low in the delivery state in order to avoid damage during transport.
Page 13
Technical specifications Technical specifications Input connections Power supply Rubber panel plug C14 Line in bass drum 2 × 6.35-mm jack socket Output connections Line out (R/L mono) 2 × 6.35-mm jack socket Power consumption 120 W Supply voltage 220 V 50 Hz Dimensions (W ×...
Page 14
When disposing of the device, comply with the rules and regulations that apply in your country. You can also return your old device to Thomann GmbH at no charge.
Need help?
Do you have a question about the Millenium Drums MPS-1000 E-Drum Monitor BD and is the answer not in the manual?
Questions and answers