Page 3
Table of contents Table of contents Safety instructions.......................................... 4 Contents of package........................................5 Assembly.............................................. 6 Protecting the environment....................................11 MPS-500...
Safety instructions Safety instructions DANGER! Danger for children Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts (e.g. knobs or the like) from the unit. They could swallow the pieces and choke! Never let children unattended use electrical devices.
Contents of package Contents of package Before you assemble your kit, make sure the contents of package is complete according to the following list. Millenium MPS-500 e-drum set Millenium MPS-500 e-drum module Pads: 1 × 8" snare / stereo 3 × 8" tom / mono 1 ×...
Assembly Assembly Assembling the rack CAUTION! Danger of cuts on hands and fingers When plugging the connections, take care for sharp edges on the metal pipes, screws etc. Loosen the screws of each terminal before inserting the pipes. Mount the various elements in the specified sequence. The posi‐ tions of the pads, cymbals, etc.
Page 7
Assembly Connect the pipe (2) to the upper terminal of pipe (1). Roughly align the height of the terminal on pipe (3) according to the height of their counter-terminal on pipe (1) vor. Con‐ nect pipe (2) to the upper terminal of pipe (3) and tighten the screws of the terminals with the drum key evenly hand-tight. Connect the side arms (5) and (6) to the terminals of the pipes (4) and (7) and tighten the screws of the terminals with the drum key evenly hand-tight.
Page 8
Assembly Connect the right side arm (pre-mounted pipes 6 and 7) to the lower terminal of pipe (3) and tighten the screws of the terminals with the drum key evenly hand-tight. Connect the short side arm (8) to the lower terminal of pipe (1) and tighten the screws of the terminals with the drum key evenly hand-tight.
Page 9
Assembly Mounting cymbals on the rack Put the three cymbal holders as shown into the designated terminals on the rack. Tighten the screws of the terminals firmly and evenly. Unscrew the wing nuts (9) from the cymbal holders and take the felt washers (10) off the holders. Place the four cymbals as shown in the figure on the holders Then place the felt washers (10) on the cymbals and fix the cymbals with the associated wing nuts (9) on the holders.
Page 10
Assembly Mounting the drum module on the rack Put the drum module up to the stop into the empty terminal of the left side arm. Align the module and tighten the wing nut of the terminal. Mounting the bass pedal Snap the two metal rods into the holes provided on the frame of the pedal.
Protecting the environment Protecting the environment Disposal of the packaging material For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling.