Page 3
Table of contents Table of contents Safety instructions.......................................... 4 Contents of package........................................5 Assembly.............................................. 6 Protecting the environment....................................12 MPS-100...
Safety instructions Safety instructions DANGER! Danger for children Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts (e.g. knobs or the like) from the unit. They could swallow the pieces and choke! Never let children unattended use electrical devices.
Page 5
Contents of package Contents of package Before you assemble your kit, make sure the contents of package is complete according to the following list. Millenium MPS-100 e-drum set Millenium e-drum module Pads: 4 × snare / tom 1 × bass drum 3 ×...
Assembly Assembly Assembling the rack CAUTION! Danger of cuts on hands and fingers When plugging the connections, take care for sharp edges on the metal pipes, screws etc. Loosen the screws of each terminal before inserting the pipes. Mount the various elements in the specified sequence. The posi‐ tions of the pads, cymbals, etc.
Page 7
Assembly Connect the left side pipe (mainstay L) to the left base and tighten the allen screw of the terminal with the supplied drum key firmly. Stabilise the unit with a crossbar (see figure). Then connect the right side pipe (mainstay R) to the right base and tighten the allen screw of the terminal firmly with the supplied drum key.
Page 8
Assembly Connect the top left side arm (L1) to the second terminal and the lower left side arm (L2) to the third terminal of the left side panel. Tighten the allen screws of the terminals firmly with the supplied drum key. Then connect the right side arm (R) to the second terminal of the right side panel and tighten the allen screws of the terminal firmly with the supplied drum key.
Page 9
Assembly Mounting pads on the rack Attach the supplied L-pieces to the pads. Tighten the wing nuts on the pads by hand first. Then slide the plastic ends of the L- pieces up to the stop into the designated terminals on the rack (see figure). Align the pads on the rack to meet your needs, then tighten the wing nuts of the pad brackets and the bolts of the retaining terminals on the rack firmly and evenly.
Page 10
Assembly Put the cymbal holders into the designated terminals on the rack (see figure) and tighten the allen screws of the terminals firmly with the supplied drum key. Unscrew the wing nuts from the cymbal holders and take the felt washers off the holders. Place the cymbals as shown in the figure on the holders.
Page 11
Assembly Kick drum pedal and pad Snap the two metal rods into the holes provided on the frame of the kick drum pedal. Place the beater into the hole provided on the rotary head of the pedal and tighten the terminal. Attach the drum pedal with the two screws on the bass drum pad and attach the beater to the pedal (see figure).
Protecting the environment Protecting the environment Disposal of the packaging material For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling.