Table of Contents
Advertisement
Chapter 2 The Web Configurator
Enter the user name ("user" is the default) password ("1234" is the default) or
2
enter the administrator user name ("webadmin" is the default) and password
("1234" is the default) and click OK.
You should now see the main Status screen (refer to
3
2.2.1 Logging Out of the Web Configurator
To log out of the Web Configurator - perhaps to log in under a different account -
you must close the web browser in which it is displayed and then clear your
browser cache. If you do not, then the next time you re-open the web page in that
browser you may not have been properly logged out.
For instructions on how to empty your web browser cache, see the documentation
that shipped with it.
2.2.2 Resetting the ZyXEL Device
If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the ZyXEL Device to reload the factory-
default configuration file. This means that you will lose all configurations that you
had previously and the password will be reset to "1234".
2.2.2.1 Using the RESET Button
Make sure the PWR and SYS LEDs are on (not blinking).
1
Press and hold the RESET button for about 15 seconds. All LEDs (except the
2
WLAN LED on the P-974HW) should turn on. When you release the RESET
button, the defaults have been restored and the ZyXEL Device restarts.
24
Figure 4 on page
25).
P-974H/HW Series User's Guide
Advertisement
Table of Contents
